Saltamontes Posted August 11, 2009 Share Posted August 11, 2009 My Patagonia breathable waders have a leak, how do I pinpoint where this leak is? any tips, tricks? Quote Link to comment Share on other sites More sharing options...
maxwell Posted August 11, 2009 Share Posted August 11, 2009 run a flashlight along teh seams.. i turn em inside out n sharpie the places the light shines through! then goop em! or aquaseal Quote Link to comment Share on other sites More sharing options...
126barnes Posted August 11, 2009 Share Posted August 11, 2009 I used the vapour barrier tape you use on the outside of houses. Put it on the indisde of the waders and it workd like a charm...............$14 dollar a roll at Crappy Tire and you got a lifetime of supply of patches...................and you don't have to wait for drying time...................I also use it to patch holes in my alumnium canoe..............two years and counting.............I wonder why nobody wants to float the Gander with me in my canoe. Quote Link to comment Share on other sites More sharing options...
cheeler Posted August 11, 2009 Share Posted August 11, 2009 Rubbing alcohol will cause the leak area to turn dark when you apply it to the inside of the waders. Quote Link to comment Share on other sites More sharing options...
Taco Posted August 11, 2009 Share Posted August 11, 2009 Rubbing alcohol will cause the leak area to turn dark when you apply it to the inside of the waders. Spray it on with pump type spray bottle Quote Link to comment Share on other sites More sharing options...
SilverDoctor Posted August 11, 2009 Share Posted August 11, 2009 I have always used the old method of filling the waders with water and looking for where they leak. Quote Link to comment Share on other sites More sharing options...
ÜberFly Posted August 11, 2009 Share Posted August 11, 2009 Lornce, I have tried this too, but it can be dicey if the leak is quite high up and that's a lot of water to try and hold up!! Spraying rubbing COOH works really well as the youtube vid suggests. Sealing the inside of the wader is the way to go unless you want your waders to show a bit of character... P I have always used the old method of filling the waders with water and looking for where they leak. Quote Link to comment Share on other sites More sharing options...
Simpson Posted August 11, 2009 Share Posted August 11, 2009 run a flashlight along teh seams.. i turn em inside out n sharpie the places the light shines through! then goop em! or aquaseal Nice Max! Seems like a sound method to me. I have had a few leaks lately. Placed my compressor hose inside them with a tight grip around the hose while my wife spray with soapy water...look for the bubbles. I would just fill them and release a little more air at a time. Problem I do see with it is the pressure on the seams..I was careful with the amount of air I released...but a large bang noise would be a bad thing. I like Max's idea...going to give it a try as the suckers are still leaking a tube of aqua seal later! Ready for a new pair! Quote Link to comment Share on other sites More sharing options...
Pipestoneflyguy Posted August 11, 2009 Share Posted August 11, 2009 I did the same as Lornce but turned mine inside-out first - also I'm not worried about leaks above the waistline - used loon to repair Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.