monger Posted December 14, 2013 Share Posted December 14, 2013 I'm trying to solder a fitting on to my 3/4" vertical copper pipe coming up from my water heater (changing out some Poly B water lines for PEX). Therefore I need the solder to go up against gravity to secure the joint. Well, gravity is winning and a plumber I ain't (X3). I need a Pro for a 10 minute job apparently. Any recommendations? Cheers, Rob, not a plumber Quote Link to comment Share on other sites More sharing options...
shredneck Posted December 14, 2013 Share Posted December 14, 2013 If you use flux and get it hot enough it should pull the solder right up. The propane in the yellow bottle works better then the blue bottle(hotter) At least this has been my experience.... I am however NOT a plumber. Quote Link to comment Share on other sites More sharing options...
monger Posted December 14, 2013 Author Share Posted December 14, 2013 Thanks for your input Got flux...but no upward migration of solder (just downhill flow). Lack of skill/knowledge gets frustrating after a while Quote Link to comment Share on other sites More sharing options...
pokerfish Posted December 14, 2013 Share Posted December 14, 2013 not a plumber, but did a couple cabins. capillary action will draw the solder up into the joint - against gravity. But you need to have the parts clean, fluxed AND you must heat the joint itself. you can tell when the joint is hot enough, cuz the solder melts when pressed against the joint - and the flame is not pointed there. Quote Link to comment Share on other sites More sharing options...
monger Posted December 15, 2013 Author Share Posted December 15, 2013 OK, I have had 3 failures. Parts are clean and fluxed. I guess I need to heat the fitting even more and then remove the flame??? The solder is melting...but it is not getting sucked up into the joint. How do you know if the capillary action is working? How much do flyfishing non-plumbers charge for house calls? Quote Link to comment Share on other sites More sharing options...
monger Posted December 15, 2013 Author Share Posted December 15, 2013 Well I paid for a lesson. I was getting things too hot. Quote Link to comment Share on other sites More sharing options...
Castuserraticus Posted December 15, 2013 Share Posted December 15, 2013 Done right, you'll see the solder pull up into the joint. Inside and outisde (male and female) of pipes have to be clean - emory paper to get all oxidation off. Flux on inside and outside. Any slow drip of water will prevent the solder from bonding. At the right temperature, the flux will start to smoke/vaporize and the solder will melt and pull into the joint. Quote Link to comment Share on other sites More sharing options...
monger Posted December 15, 2013 Author Share Posted December 15, 2013 A pro did it for me...job done. Joint was clean and fluxed when I tried, but I believe I used too much heat so the solder would just run down the pipe with none remaining up in the joint (or not enough). I believe there is a temperature range where the capillary action will work...and once over that, the solder just runs away. I tried increasing temperature on each successive attempt, but I believe I should have used less heat. The family was wanting some water before the day was over so I had to hire a guide. I got a lesson. Hopefully next time I'll be smarter. Thanks for everyone's input Quote Link to comment Share on other sites More sharing options...
shredneck Posted December 16, 2013 Share Posted December 16, 2013 Glad it worked out eventually Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.